| Question:
Recently my
water bills appear to be rather high. None of the faucets appear
to leak. What else could contribute to a high water bill? |
| Answer:
You may want to check to see if a toilet is leaking. First, check
the water level to ensure that water is not overflowing the tank
by way of the overflow pipe. This is the pipe in the middle of the
tank. It has a small tubing connected to it. If water is running
into the overflow, adjust the fill valve to stop the flow
approximately 1inch below the top of the overflow tube or to the
water level mark stamped on the side of the tank. Second, put a
few drops of food coloring into the tank to test the flush valve
mechanism. If the water in the bowl changes color within 15
minutes, this is an indication that water is leaking into the
toilet bowl and that the ball or flapper needs to be replaced.
|
| Question:
How often
should I have my septic system inspected? |
| Answer:
Septic systems should be inspected and pumped a minimum of once
every three to four years. You may not be experiencing any problem
now, but a full septic tank may allow unwanted solids to flow into
the drain field, which is the part of the system that consists of
a distribution box, with a series of connected pipes. Each pipe
allows water to flow into a bed of stone, that drains into the
ground. If paper and other solids flow into the drain field it
becomes blocked and ineffective. A blocked drain field is costly
to repair or replace.
|
| Question:
The
temperature of my hot water seems to be higher than what I think I
need. How can I conserve energy, yet also be sure that there is an
adequate amount of hot water? |
| Answer:
Most people are comfortable with their hot water set at 120
degrees Fahrenheit, which is also the new standard that
manufacturers use when pre-setting it at the factory. If you have
an older model, set the thermostat at medium. On a gas model,
there is a dial on the front of the gas valve. On electric models,
the thermostats (there may be two) are concealed behind the two
panels on the side of the tank. NOTE: Turn
off the electricity
before removing the panels. There are exposed wires behind the
panels containing HIGH VOLTAGE.
|
| Question:
I have a foul odor coming from my garbage
disposer. What can I do to eliminate this odor? |
| Answer:
Foul odors occur from
a buildup of food debris within the disposer. To eliminate this
odor, place ice cubes and lemon or orange peels in the disposer
and run for 30 seconds. Next, squirt a little liquid dish
detergent into the disposer while it is still running. Finally,
run cold water for about 30 seconds to rinse all the debris away.
|
| Question:
I am
getting a foul odor from a bathroom in the basement. We hardly
ever use this bathroom except when we have company. This is
embarrassing. What can we do? |
| Answer:
Plumbing systems are designed to prevent foul odors from entering
the house by means of the trap attached to fixtures. Traps contain
water to seal out foul odors; if the water seal evaporates, the
odors enter the house. To solve this problem, pour a bucket of
water in each trap, sink, shower and floor drain. This will
prevent the odors from entering the house.
|
| Question:
We
live in northern Ohio. Winters are cold and we were told to turn
off the outside faucets in the fall before the freezing weather
arrives. We did this, however the pipes leading to our outside
faucet still froze and broke. What did we do wrong? |
| Answer:
Turning off the water is not enough. You must also disconnect the
garden hose connected to the faucet to allow the water in the pipe
to drain out. This will allow the piping to withstand the cold
weather.
|
| Question:
My
shower head and faucet aerators have a buildup of a white
substance around the area where the water comes out. Is there
anything I can do other than replacement? |
| Answer:
The unsightly buildup is mineral deposits. To remove these
deposits from the showerhead, take a plastic bag and pour a cup of
vinegar in it. Place the bag over the showerhead and use a twist
tie to hold it in place overnight. In the morning, remove the bag
and use an old toothbrush to gently scrub the deposits off. You
might be able to remove the aerators from the faucets and allow
them to soak in the vinegar overnight.
|
| Question:
Our kitchen
drain has taken longer than usual to drain during the past year.
Should we have it cleaned? |
| Answer:
Before you have the drain cleaned, try using the Roto-Rooter brand
drain maintenance products. These products are designed to remove
the usual buildup of soap scum, grease and hair. We also have a
product to inhibit root growth in your main sewer line. All of
these products are guaranteed and are available through your local
Roto-Rooter office.
|
| Question:
When I am in the laundry room and the water heater is operating, I
hear a rumbling sound coming from the water heater. What could
cause this? |
| Answer:
Rumbling sounds coming from a water heater are an indication that
sediment is built up on the bottom of the water heater. What you
are hearing is water that is trapped in the sediment and is
boiling. This is an indication that the water heater is not
operating efficiently. Sediment will not allow the heat to
transfer to the water in the tank, which sends the heat up the
flue.
You may try draining a few gallons of water off the bottom of
the water heater tank. This is done by attaching a drain hose to
the valve at the bottom of the tank. Allow it to drain for about
five minutes.
WARNING: HOT WATER IS DANGEROUS. DISCHARGE THE WATER INTO A
FLOOR DRAIN, LAUNDRY TUB OR BATHTUB. HOT WATER WILL KILL YOUR
GRASS IF DISCHARGED ONTO THE LAWN. HOT WATER WILL CRACK A TOILET
BOWL IF DISCHARGED INTO THE TOILET.
Many newer models of water heaters have a new feature that
prohibits the buildup of sediment in the tank. If your heater is
an older model, it may be cost effective to replace the water
heater if the buildup is severe.
|
| Question:
I
am hearing a whistle sound that seems to be connected to the
plumbing system. It comes and goes at times, but I can't find the
cause of it. What could cause this? |
| Answer:
The sound you are describing is usually caused by a toilet fill
valve that is slowly leaking. To locate the offending toilet,
remove the lid of each toilet tank and adjust the fill valve
mechanism until it stops. Once you have found the toilet causing
the problem, repair or replace the fill valve.
|
| Question:
We
need to replace a toilet in our home. We have heard coworkers and
friends complain that the new toilets do not flush properly, and
that they require multiple flushes. What is the recommendation for
toilet replacement? |
| Answer:
When the federal government mandated that new toilets use no more
than 1.6 gallons per flush, manufacturers had to develop a toilet
that would achieve this but that would also flush properly (clear
the bowl) and carry the waste to the city sewer or septic system.
Some of the early models did not do this properly. Since then, the
complaints have forced the manufacturers to develop new ways of
flushing toilets. One new way is the use of a pressurized toilet
tank. This model looks like a regular toilet, but it has a
pressure tank inside. When flushed, it works like a commercial
toilet. A large surge of water enters the bowl and clears the bowl
of any waste. These toilets work well, but are not as quiet as a
conventional model.
When considering a new fixture for your home such as a toilet,
I recommend you choose a fixture made by one of the major
manufacturers, such as American Standard, Kohler or Eljer.
|
| Question:
There are
four people in our house, two adults and two teens. We are
constantly running out of hot water. After a five-minute shower,
the water starts to turn cold. This change occurred quite
recently. Help! |
| Answer:
There are two possibilities. First, the dip tube has broken off.
This is a tube that forces incoming water to the bottom of the
tank so that hot water will be drawn off of the top. When the dip
tube breaks, cold water entering the tank mixes with the hot water
and cools it down. This can occur in both gas and electric models.
Second, if your water heater is electric, the lower element
that heats the water may not be operating properly, thus only the
upper half of the tank will heat up. The cause of this problem
could be a bad element or a thermostat malfunction. This type of
problem should be evaluated by a qualified technician.
|